Menu
The Steris Reliance® 444 Single-Chamber Washer/Disinfector is a mechanical washer equipped with an Eagle® 3000 Stage 3™ control system. It meets the highest standards of cleaning performance and maximum throughput. RELIANCE 444 SINGLE-CHAMBER WASHER/DISINFECTOR Amsco/Steris Pulstar 5000 Glassware Washer. Amsco/Steris Pulstar 1200 Endoscope Processor Manual. Amsco/Steris Reliance 3400 Washer Sterilizer. Amsco/Steris Sparkle Series Glassware Dryer Manual. Amsco/Steris Sparkle II Glassware and General Purpose Washers. Amsco/Steris Model 8816A. Reliance® 444™ Washer/Disinfector Introduction: This self paced instructor led training at our Mentor, Ohio service training facility will provide your equipment technicians with the knowledge they need to operate and perform maintenance on the Reliance® 444™ Washer/Disinfector.
Description
Steris Amsco Reliance 444 Service Manual
Dimensions
- Exterior dimensions: 80″H x 42″W x 32.625”D (2032 x 1067 x 829 mm)
- Interior chamber dimensions: 26″H x 24″W x 24”D (660 x 610 x 610 mm)
- Load Height: 31” (787 mm) above finished floor
General
Steris Amsco Reliance 444 Service Manual
- Vertical sliding power door(s) is constructed of tinted, tempered glass with stainless-steel trim to allow the operator to
- view the chamber with the door closed. While a cycle is in progress, glass door remains cool to the touch.
- Sliding door(s) is configured for power door operation.
- Door is opened and closed automatically using touch pads on the control panel, located on the same side of the washer/disinfector as the door being operated.
- Each power door includes a safety sensor to retract the door if an obstruction is detected in the doorway. If a power failure occurs, door(s) can be opened manually.
- The manual access handle is located on the top edge of the door and concealed behind the top service panel. If double power doors are ordered, a door interlock feature is provided to help prevent cross-contamination.
- Stainless-steel pump is powered by a dual-speed motor.
- High pump speed provides the equivalent capacity of a 7.5 HP (5.6 kW) motor, 240 U.S. gal/min at 70 ft (910 L/min at 21.3 m) head pressure. Low pump speed provides the equivalent capacity of a 2 HP (1.4 kW) motor, 90 U.S. gal/min at 25 ft (341 L/min at 7.62 m) head pressure. Pump impeller is mounted directly on this motor shaft and does not require additional bearings.